Zhone 3825Plus Guía de usuario descargar pdf (Pagina 5)

DTE Connection

Use the following procedure to connect the RS-232-E cable from the modem to the

DTE:

" Procedure

1. Make sure the modem’s rear panel power switch is Off.

2. Connect the DB-25-P plug on the cable to the DB-25-S socket labeled

COMPUTER on the modem’s rear panel. Use a small screwdriver to fasten the

cable to the modem.

3. Connect the other end of the cable to the serial connector on the DTE. Use a small

screwdriver to fasten the cable to the DTE.

Dial-Line Connection

Use the following procedure to connect a 3825Plus to the dial network interface.

" Procedure

1. Insert the 6-position, 4-conductor modular plug into the jack labeled LINE.

2. Insert the other end of the modular cord into the dial network interface.

2-Wire Leased-Line Connection

Use the following procedure to connect a 3825Plus modem to the 6-pin, center pair,

leased-line network interface. A description of the JM8 to RJ11C crossover cable

required can be found in the user’s guide.

" Procedure

1. Insert the 6-position, 4-conductor modular plug into the jack labeled LINE.

2. Insert the other end of the modular cord into the leased-line network interface.

Telephone Connection

Use the following procedure to connect the modem to a single-line or two-line

telephone:

" Procedure

1. Insert the 6-position, 4-conductor modular plug into the jack labeled PHONE.

2. Insert the other end of the modular cord into the telephone.

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sin comentarios

Zhone 3825Plus Guía de usuario Pagina 5