Zhone 4821-A2 Información técnica descargar pdf (Pagina 14)

1. System Concepts

1-2 July 2004 4821-A2-GB21-00

Unit

A single 1U chassis is referred to as a unit.

Port ID

Port ID is the generic term used to refer to a DSL or Ethernet port in this document

regardless of what method is used. For DSL ports, the port ID can be a number

from 1 to 24, or an interface name as described below. The fast Ethernet ports are

named eth1 and eth2.

DSL Port ID

There are several ways a DSL port can be identified in the unit.

Interface Number. DSL ports 1–24 of the unit can be referred to by the numbers

1–24 respectively.

Example:

PDYN# configure interface dsl 24 line-code dmt

Interface Name. You can use the configure interface dsl name command to

assign a name to the port, which you can then use instead of the number.

Example:

PDYN# configure interface dsl room_401 line-code dmt

Port Name or Number with Priority Group. You can additionally specify a

specific priority group to modify. The priority group is specified using a colon (:)

and a number from 1 (lowest priority) to 8 (highest priority) after the port name or

number. If no priority group is specified, then group 1 is assumed.

Example:

PDYN# configure interface dsl room_401:8 line-code dmt

All. The keyword all may be used to specify all DSL ports in a command that

refers only to DSL ports.

Example:

PDYN# configure interface dsl all line-code dmt

Range. Any of the port ID types may be used as an operator in a range

specification. The only requirement is that the port used as the first operator in a

range must have a lower interface number than the second operator.

Example:

PDYN# configure interface dsl 1-24 line-code dmt

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 183 184

Sin comentarios

Zhone 4821-A2 Información técnica Pagina 14