Zhone Hotwire 6390 Guía de instalación descargar pdf (Pagina 23)

2. Installation

8620-A2-GN20-50 June 2004

2-5

8620 BAC Installation

The 8620 BAC is designed to be placed on a desktop or table, or mounted in a

19-or 23-inch rack (front or center mount). Installable feet are provided for desktop

or table installations. Mounting brackets are provided for mounting in 19- or

23-inch racks.

NOTE:

Do not attach the rubber feet to the chassis if you plan to install it in a rack.

The rubber feet will cause the chassis to exceed 3U in height, limiting the

maximum number of chassis that can be installed in a rack.

You will need a large flat-blade screwdriver and a Phillips screwdriver to install the

8620 chassis.

Placing the 8620 Chassis on a Desktop or Table

Procedure

To install the 8620 chassis on a desktop or table:

1. Make sure that the bottom of the chassis is clean so that rubber feet will stick

to its surface.

2. Invert the chassis on a protected surface (to avoid scratching the paint).

3. Remove the protective backing from one of the rubber feet and place it in a

corner about 1/2 inch (1.27 cm) from each of the edges of the chassis,

pressing down firmly to ensure proper bonding.

4. Repeat Step 3 for each of the remaining three feet.

5. Turn the chassis right side up and place on a flat surface where desired.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 57 58

Sin comentarios

Zhone Hotwire 6390 Guía de instalación Pagina 23