Zhone SPEED-DSL 4.6 Manual de instrucciones descargar pdf (Pagina 6)

SPEED-DSL 4.6

SPEED-DSL 4.6/22.10.2004 page

1.5. Connect the Ethernet Line

Plug the Ethernet cable into the Ethernet Connection RJ45 port on the back of the SPEED-

DSL 4.6. Verify the connection: solid illumination of the Ethernet Connection Lnk LED on the

front of the SPEED-DSL 4.6 indicates a link has been established, IF an SDSL connection has

already been made. If an SDSL connection has NOT yet been made, the Ethernet link will

remain disabled (as indicated by solid illumination of the Ethernet Rx, Tx and Lnk LEDs) until

at least one of the two SDSL links has been established.

SDSL 2

Power Adapter

Configuration

Ethernet Connection

5V DC

SDSL 1

SDSL 2

SPEED-DSL 4.6

SDSL 1

SDSL Connection

SDSL

Connection

Power

Collision Rx Tx Lnk

Ethernet Connection

NOTE

For most applications, the SPEED-DSL 4.6 connects to a PC using a straight-

through Ethernet cable and to a hub or a switch using a crossover

Ethernet cable. For any other connection combinations you must verify the

pinout of the Ethernet device into which you are connecting the SPEED-DSL

4.6 in order to determine which type of cable is required.

ETHERNET RJ45

PORT

PIN CONNECTION

1 Rx+

2 Rx-

3 Tx+

4 not used

5 not used

6 Tx-

7 not used

8 not used

ETHERNET CABLE: RJ45 CONNECTOR

1.6. Ferrite Chokes

If ferrite chokes are included with your Speed-DSL 4.6, bundle together all power and signal

cables and wrap all the cables with all the ferrite chokes. Position the ferrite chokes as close

as possible to the Speed-DSL 4.6.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Zhone SPEED-DSL 4.6 Manual de instrucciones Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Zhone SPEED-DSL 4.6