Zhone Speed-DSL 9.2 Manual de instrucciones descargar pdf (Pagina 6)

SPEED-DSL 9.2

SPEED-DSL 9.2/22.10.2004 page 6

G.SHDSL RJ45 Pinout

PIN CONNECTION

1 not used

2 not used

3 not used

4 ring

5 tip

6 not used

7 not used

8 not used

Link up time between local and remote G.SHDSL network extenders can vary from one to five minutes

depending on the quality, gauge and distance of the copper cable pair being used. If the cable distance is

greater than a particular bandwidth will support, the units may not link up or, if they do achieve link, traffic

quality may be affected (e.g., packets may be dropped).

1.5 Connect the Ethernet Line

NOTE

If a G.SHDSL connection has not yet been made, the Ethernet link will remain disabled (as indicated

by solid illumination of the Ethernet 100, Act and Lnk LEDs) until at least one of the four G.SHDSL

links has been established.

1.5.1 Duplex Mode

The 10/100 Ethernet port auto-negotiates speed and duplex mode in accordance with the remote

equipment to which it's connected; Ethernet speed and duplex mode configurations cannot be hard set

on the SPEED-DSL 9.2. For the best connection results, the remote device (PC, hub, switch, etc.) should

be set to auto-negotiate speed and duplex mode as well. If the remote device cannot be configured to

auto-negotiate, speed may be hard set at either 10 Mbps or 100 Mbps but duplex mode must be hard set

to Half Duplex; a 10/100 Ethernet connection will not operate properly if the remote device is hard set to

Full Duplex.

1.5.1.1 Half Duplex

Receive and transmit functions are mutually exclusive; data transmission occurs in only one

direction at a time. Packet collisions are not unusual.

1.5.1.2 Full Duplex

Receive and transmit functions occur simultaneously, effectively doubling aggregate bandwidth and

preventing packet collisions.

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Zhone Speed-DSL 9.2 Manual de instrucciones Pagina 6