Zhone MIM-2T1 Guía de usuario descargar pdf (Pagina 4)

4 October 2004 MIM2-A2-GZ41-00

Connecting the T1 Line

A primary feature of the MIM-2T1 is loop bonding capability, though the module

can function with a single T1 connection as well.

NOTE: A MIM-2T1 must be connected with T1 provider equipment; a connection

between the MIM-2T1 and T1 subscriber equipment will not function.

Loop Bonded Connection

Using two T1 lines for one network connection (loop bonding ) will net twice the

speed and data passing capability as a single T1 connection. A second T1 line

also provides backup should one of the lines become disabled. A MIM-2T1 can

only establish loop bonded connections with other loop bonding capable T1

provider equipment; refer to the T1 Loop Bonding Product to Product Feature

Compatibility list (Document Number COMP-A2-GK43 ).

Procedure

1. If a ferrite choke is supplied with your MIM:

— Open the ferrite choke.

— Make a loop at the end of your cables and close them in the ferrite choke.

Position the choke as close as possible to the RJ45 connectors.

— Snap shut the ferrite choke.

2. Plug your T1 cables into the T1 RJ45 ports (Port 1 and Port 2) on the MIM-2T1

faceplate; the order of connection is not important.

3. Verify both connections: the Port 1 and Port 2 Lnk LEDs on the MIM-2T1

faceplate will flash green to indicate the connections are established and

operational.

04-17593

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Zhone MIM-2T1 Guía de usuario Pagina 4