Zhone 3920Plus Manual de instrucciones descargar pdf (Pagina 153)

Configure Branch

5-773920-A2-GH30-40 October 1998

Table 5-14

(5 of 5)

Miscellaneous Configuration Options — Singleport Mode A

Diag Connection: Modem(DC)

Nxt Modem(DC) NMS(CC) Disable

Diagnostic Connection. Allows the configuration of the serial diagnostic port of the modem to be either a diagnostic

channel that is connected to another modem (DC), or a control channel that is connected to a network management

device (CC).

NOTE: TMp tributaries cannot be diagnostically extended, therefore the Diag Connection configuration option is forced

to Disable.

NOTE: Changes to this configuration option will cause the modem to reset.

Modem (DC) – Selects the Diagnostic Channel.

NMS (CC) – Selects the Control Channel.

Disable – Prevents messages being sent from the diagnostic port.

The AT command is S-Register S90 = n, where n is 0 Modem(DC) and 1 for NMS(CC) and 2 for Disable.

Mixed Trib F/W: No

End No Yes

This configuration option is only available when the modem is configured for TMp Control.

Mixed Tributary Firmware. Establishes that a multipoint network has TMp tributary modems using firmware prior to

Release M02.00.xx.

No – Multipoint network modems do not have mixed firmware.

Yes – Multipoint network modems do have mixed firmware.

Link Delay(sec): 0 1

Nxt 0 1 2 5 10 20 50

Link Delay Seconds. Controls the length of time (in seconds) a modem will wait for responses from the downstream

devices. This configuration option is used to calculate protocol timers for polling and normal selection.

NOTE: The estimated roundtrip delay in the diagnostic link is entered.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 353 354

Sin comentarios

Zhone 3920Plus Manual de instrucciones Pagina 153