Zhone 3920Plus Manual de instrucciones descargar pdf (Pagina 165)

Control Branch

7-53920-A2-GH30-40 October 1998

To enable or disable the modem’s data transmitter function on all ports, press the appropriate

function key, F1 (Enable) or F3 (Disable). When the message Command Complete appears,

press the

key to clear the message.

Select DS Port >

All

To change the data stream on all ports again, press the F1 key.

To exit this function and remain in the Control branch, press the

key. To exit and return to

the Top-Level menu, press the

key.

EIA LEDs

This function allows the front panel EIA LEDs to display and change the activity of a selected

digital interface. Use the EIA LEDs function to change the port that controls the front panel

LED.

Based on the modem’s configuration, the following conditions exist:

• The CC or DC selection is not available if the Diagnostic Connector configuration option

is disabled. Refer to the Diag Connection configuration option in the Misc section of

Chapter 5, Configure Branch.

• The CC or DC interface is not available on the 3921Plus modem. The CC or DC activity

is monitored on the SDU in the 3000 Series carrier.

• Ports 3 or 4 are not available in the DTE Bridge mode.

• Ports 2, 3, and 4 are available in TDM/MSD mode.

To access EIA LEDs from the Control branch, make the following selections:

Control:

EIA_LEDs

Press the key until EIA LEDs appears. Select EIA LEDs.

EIA LEDs:xxxxx >

Port1 Port2

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 353 354

Sin comentarios

Zhone 3920Plus Manual de instrucciones Pagina 165