Zhone 3920Plus Manual de instrucciones descargar pdf (Pagina 249)

AT Command Set and S-Registers

14-173920-A2-GH30-40 October 1998

Table 14-3

(1 of 15)

392xPlus S-Registers

S-Register

Description

DCP LCD

Command

Sequence

S0 Auto-Answer Ring Number

. Register determines number of rings the modem

will count before automatically answering a call.

Enter zero (0) if you do not want the modem to automatically answer any calls.

Otherwise, enter a value from 1–255 for the number of rings to count before

answering. The factory setting is 1.

Configure\Edit\

Line Dialer

S2 AT Escape Character. Register determines ASCII value used for escape

sequence to enter Command mode from Data mode.

Enter a value from 0 to 127 for the escape character. Any value greater than

127 causes the modem to disable the escape sequence. When the escape

sequence is disabled, the modem cannot return to Command mode until the

call is disconnected. The factory setting is 43 (+ key).

Configure\Edit\

DTE Dialer

S3 Carriage Return Character. Register determines ASCII value used as the

carriage return (Return key). This character is used to end command lines and

result codes.

Enter a value from 0 to 127 for the command end character. The factory

setting is 13 (carriage return key).

Configure\Edit\

DTE Dialer

S4 Line Feed Character. Register determines ASCII value used as the line feed

character.

Enter a value from 0–127 for the line feed character. The factory setting is 10

(ASCII carriage return or line feed).

Configure\Edit\

DTE Dialer

S5 Backspace Character. Register determines ASCII value used as the

backspace (Backspace key). This character moves the cursor to the left and

erases the previous character.

Enter a value from 0–127. The factory setting is 8 (backspace key).

Configure\Edit\

DTE Dialer

S6 Blind Dial Pause

. Register determines how long (in seconds) the modem

waits after going off-hook before dialing a telephone number if using result

code X0, X1, or X3.

Enter a value from 2–255 seconds. The factory setting is 2.

Configure\Edit\

Line Dialer

S7 No Answer Timeout

. Register determines how long (in seconds) an

originating modem waits before abandoning a call when no answer tone is

received.

Enter a value from 1–255 seconds. The factory setting is 45.

Configure\Edit\

Line Dialer

S8 “,” Pause Time for the Dial Modifier. Register determines how long (in

seconds) the modem pauses when it encounters a comma (,) in the Dial

command string.

Enter a value from 0–255 seconds. The factory setting is 2.

Configure\Edit\

Line Dialer

S10 No Carrier Disconnect

. Register determines how long (in tenths of seconds)

the modem allows the carrier signal to be OFF before disconnecting the call.

Enter a value from 0–254 in 0.1 second increments. A value of 255 disables

this register. The factory setting is 20 (2 seconds).

Configure\Edit\

Line Dialer

The range of allowable values may be restricted in some countries.

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 353 354

Zhone 3920Plus Manual de instrucciones Pagina 249

Comentarios a estos manuales

Zhone 3920Plus Manual de instrucciones Pagina 249

Comentarios a estos manuales

Relacionado con productos y manuales para Módems Zhone 3920Plus